JET Performance Power-Flo

JET Performance Power-Flo

Installed the JET Performance Throttle Body and Throttle Body Spacer.

Item: JET Power -Flo Throttle Body for a 2017 Jeep JK Chief Unlimited & JET Performance Throttle Body Spacer

Vendor: Extremeterrain.com

Jeep Torque Wrenches: 2 out of 5.

Not too bad to remove the old throttle body and install the new JET Performance Power-Flo along with the nice spacer they have as well that fit right inside of the upper intake manifold. Make sure not to tighten the bolts too much on the JET Performance Power-Flo Throttle Body, its plastic the upper intake. I have an unlocked PCM with a Traildash 2 SuperChips installed, along with an SEC10 pedal adjuster. I set my SEC10 to stock (grey button), left my TrailDash2 on 93 Octane power. I then followed the steps outlined for the JET Performance Power-Flo configuration: Turn the key on, press on the gas pedal three times slowly, but not to slow, not to fast, just in-between. Turn the key all the way off, then start the engine. Should be good. I noticed a difference in acceleration for sure, response wise with my SEC10 and TrailDash2 this definitely adds an additional 5-8HP.

Have a comment or question?